undervast.blogg.se

Change language remote assistant cr110
Change language remote assistant cr110








change language remote assistant cr110
  1. #CHANGE LANGUAGE REMOTE ASSISTANT CR110 FULL#
  2. #CHANGE LANGUAGE REMOTE ASSISTANT CR110 CODE#

Refer to the section on "Eliminating the Arm/Disarm Chirps" shown later in this manual. If the siren did not sound when arming, then the chirps have been turned off. At the end of the 30 seconds, the parking lights will flash once, the siren will chirp once, and the dash mounted LED will begin to flash slowly confirming the system is armed.When all entry points are closed, the arming cycle will begin again. If any entry point is opened during the 30 second arming cycle, arming will be suspended. Closing this entry point will allow the arming cycle will begin. If the LED does not begin to flash rapidly, then you have left a door, hood, or trunk ajar.

change language remote assistant cr110 change language remote assistant cr110

The dash mounted LED will begin to flash rapidly indicating that the 30 second passive arming timer has begun. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.PASSIVE ARMING: If the passive arming feature has been selected:

#CHANGE LANGUAGE REMOTE ASSISTANT CR110 FULL#

Simply close the opened entry point to provide full protection. NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood lid ajar. If you have the optional door lock/unlock circuit installed, the doors will lock. The parking lights will flash once, and the dash mounted LED will begin to flash slowly confirming the system is armed.

  • Press and hold both buttons of your key chain transmitter for 2 seconds.
  • If the siren/horn did not sound when arming, then the chirps have been turned off and you should refer to the section titled "ELIMINATING THE ARM/DISARM CHIRPS" in this manual. The parking lights will flash once, the siren will chirp once, and the dash mounted LED will begin to flash slowly confirming the system is armed.
  • Press and release the LOCK button of your key chain transmitter one time.
  • Consult your installing dealer for options that may have been installed and are not listed. Your System has many features and available options some of which are selected at time of installation.

    #CHANGE LANGUAGE REMOTE ASSISTANT CR110 CODE#

    Remote Operation for the Code Alarm CA110 Vehicle Security System










    Change language remote assistant cr110